Sips fuel, and very quiet for the price point. Very clean power output up to around 900w, then THD starts to go up and Hz is 59 at 1000w, at 1200w rated load, havent tried the full surge capacity but it started a decent sized window ac unit (surge to 1671 then settled in to 803 running, you could definately hear the engine struggle to pick up the load, but it did it, and smoothed out nice under the 803w run load of the AC unit 60.0/120.03v No included hour meter, but using plug in type.Ĭurrently 881 on the meter, so longevity yet to be determined. Waveform is nice, but governor is a tad soft, needing to be set 62.5 and avr 122v no load to get 60.0/120.0 load Only have 840 hours on it currently but the only issue it has had was a weak plug from the factory, replaced and no other issues yet. Nice waveform but AVR needs adjusted to 125v no load to hold 120v 2000 Had a minor issue with choke direction sticker being backwards, otherwise good.
No built-in hour meter, but added a plug in 120v one upon purchase. Gx390 clone, generator is a clone of the EB6500 this is a great companion for a EU3000is for mantinence cycles.Īll engines have been given the same break in, MOS2, and magnets, frequent oil changes. Strong governor response and clean output for a clone. Still testing longevity but currently has 4702 on the hour meter. would be a good companion to use during mantinence cycles for either a EU6500is or EU7000is (with load management) as well as a backup for the EM6500 it was cloned after. output is very clean, not quite as clean as EM6500 but close. Very impressive governor response for a clone, almost as snappy at picking up load shifts as a genuine EM6500, and the slight compression increase is noticeable in handling large surge loads. granted it has had a proper break in, MOS2 in oil, magnets in drainplugs and changed oil every 96 hours but still, that's a LOT of hours for a clone. this unit has 9731 on the hour meter and still fires right off. brushes need replaced after about 6000 hours, but are readily avalible, any clone brushes will fit. Tested Tool Shed SG6500E, GX390 clone, compression is a little higher than genuine GX390. Just wanted to let everyone know that this brand is something to watch for when shopping for clones. As clones go these seem to be some of the better units, as I have found out.
0 kommentar(er)
